Kontron AT8404 CLI - Manual (Page 302)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 26
5.8.14 snmptrap snmpversion
This command modifies the SNMP version of a trap. The maximum length of is 16 case-sensitive
alphanumeric characters. The parameter options are snmpv1 or snmpv2.
5.8.15 snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of name is 16 case-
sensitive alphanumeric characters.
5.8.16 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps).
Disabled trap receivers are inactive (not able to receive traps).
5.8.16.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
5.8.17 snmp trap link-status
This command enables link status traps by interface.
Note: This command does not support a “no” form.
Default snmpv2
Format snmptrap snmpversion
Mode Global Config
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using
the same IP address, the first entry is retained and processed. All duplicate entries are ignored.
Format snmptrap ipaddr
Mode Global Config
Format snmptrap mode
Mode Global Config
Format no snmptrap mode
Mode Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-server enable
traps linkmode” on page 5 - 24.
Format snmp trap link-status
Mode Interface Config