Kontron AT8404 CLI - Manual (Page 203)

AT8404 Quality of Service (QoS) Commands
Page 3 - 29 AT8404 CLI Reference Manual
3.7.4 mac access-group
This command either attaches a specific MAC Access Control List (ACL) identified by to an interface, or
associates it with a VLAN ID, in a given direction. The parameter must be the name of an existing MAC ACL.
An optional sequence number may be specified to indicate the order of this mac access list relative to other mac
access lists already assigned to this interface and direction. A lower number indicates higher precedence order. If
a sequence number is already in use for this interface and direction, the specified mac access list replaces the
currently attached mac access list using that sequence number. If the sequence number is not specified for this
command, a sequence number that is one greater than the highest sequence number currently in use for this
interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface, whereas the 'Global Config' mode
setting is applied to all interfaces. The VLAN keyword is only valid in the 'Global Config' mode. The 'Interface Config'
mode command is only available on platforms that support independent per-port class of service queue
configuration.
3.7.4.1 no mac access-group
This command removes a MAC ACL identified by from the interface in a given direction.
3.7.5 show mac access-lists
This command displays a MAC access list and all of the rules that are defined for the MAC ACL. Use the [name]
parameter to identify a specific MAC ACL to display.
Format mac access-group
[vlan ]
in [sequence <1-4294967295>]
Modes • Global Config
• Interface Config
Format no mac access-group [vlan ] in
Modes • Global Config
• Interface Config
Format show mac access-lists [name]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within the MAC ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Source MAC
Address
The source MAC address for this rule.
Destination MAC
Address
The destination MAC address for this rule.
Ethertype The Ethertype keyword or custom value for this rule.
VLAN ID The VLAN identifier value or range for this rule.
COS The COS (802.1p) value for this rule.
Log Displays when you enable logging for the rule.