Kontron AT8404 CLI - Manual (Page 250)

Utility Commands AT8404
AT8404 CLI Reference Manual Page 4 - 36
4.8.1.1 no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured pool name.
4.8.2 client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid notation in hexadecimal
format. In some systems, such as Microsoft DHCP clients, the client identifier is required instead of hardware
addresses. The unique-identifier is a concatenation of the media type and the MAC address. For example, the
Microsoft client identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the
Ethernet media type. For more information, refer to the “Address Resolution Protocol Parameters” section of RFC
1700, Assigned Numbers for a list of media type codes.
4.8.2.1 no client-identifier
This command deletes the client identifier.
4.8.3 client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard ASCII characters.
4.8.3.1 no client-name
This command removes the client name.
4.8.4 default-router
This command specifies the default router list for a DHCP client. {address1, address2… address8} are valid
IP addresses, each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Format no ip dhcp pool
Mode Global Config
Default none
Format client-identifier
Mode DHCP Pool Config
Format no client-identifier
Mode DHCP Pool Config
Default none
Format client-name
Mode DHCP Pool Config
Format no client-name
Mode DHCP Pool Config
Default none
Format default-router [....]
Mode DHCP Pool Config