Kontron AT8404 CLI - Manual (Page 50)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 14
to 61440. The twelve least significant bits are masked according to the 802.1s specification. This causes the priority
to be rounded down to the next lower valid priority.
2.2.17.1 no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to the default value. The
parameter is a number that corresponds to the desired existing multiple spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the , this command sets the Bridge Priority parameter for
the common and internal spanning tree to the default value.
2.2.18 spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and one or more VLANs so that the
VLAN(s) are no longer associated with the common and internal spanning tree. The parameter is a
number that corresponds to the desired existing multiple spanning tree instance. The vlan range can be specified
as a list or as a range of values. To specify a list of VLANs, enter a list of VLAN IDs, each separated by a comma
with no spaces in between. To specify a range of VLANs, separate the beginning and ending VLAN ID with a dash
("-").
2.2.18.1 no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and one or more VLANs so that
the VLAN(s) are again associated with the common and internal spanning tree.
2.2.19 spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Default 32768
Format spanning-tree mst priority <0-61440>
Mode Global Config
Format no spanning-tree mst priority
Mode Global Config
Format spanning-tree mst vlan
Mode Global Config
Format no spanning-tree mst vlan
Mode Global Config
Default disabled
Format spanning-tree port mode
Mode Interface Config