Kontron AT8404 CLI - Manual (Page 69)

AT8404 Switching Commands
Page 2 - 33 AT8404 CLI Reference Manual
2.5.1.1 no voice vlan (Global Config)
Use this command to disable the Voice VLAN capability on the switch.
2.5.2 voice vlan (Interface Config)
Use this command to enable the Voice VLAN capability on the interface.
You can configure Voice VLAN in one of four different ways:
2.5.2.1 no voice vlan (Interface Config)
Use this command to disable the Voice VLAN capability on the interface.
2.5.3 voice vlan data priority
Use this command to either trust or untrust the data traffic arriving on the Voice VLAN port.
2.5.4 show voice vlan
Default disabled
Format voice vlan
Mode Global Config
Format no voice vlan
Mode Global Config
Default disabled
Format voice vlan {vlanid | dot1p | none | untagged}
Mode Interface Config
Parameter Description
vlan-id Configure the IP phone to forward all voice traffic through the specified VLAN. Valid VLAN ID’s
are from 1 to 4094 (the max supported by the platform).
dot1p Configure the IP phone to use 802.1p priority tagging for voice traffic and to use the default
native VLAN (VLAN 0) to carry all traffic. Valid range is 0 to 7.
none Allow the IP phone to use its own configuration to send untagged voice traffic.
untagged Configure the phone to send untagged voice traffic.
Format no voice vlan
Mode Interface Config
Default trust
Format voice vlan data priority untrust | trust
Mode Interface Config
Format show voice vlan [interface { | all}]