Kontron AT8404 CLI - Manual (Page 67)

AT8404 Switching Commands
Page 2 - 31 AT8404 CLI Reference Manual
2.4.2 mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
2.4.2.1 no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN
Tunneling is disabled.
2.4.3 mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
2.4.3.1 no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN
Tunneling is disabled.
2.4.4 show dot1q-tunnel
Use this command without the optional parameters to display all interfaces enabled for Double VLAN Tunneling.
Use the optional parameters to display detailed information about Double VLAN Tunneling for the specified interface
or all interfaces.
Default vman
Format dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535]
Mode Global Config
Default disabled
Format mode dot1q-tunnel
Mode Interface Config
Format no mode dot1q-tunnel
Mode Interface Config
Note: When you use the mode dvlan-tunnel command on an interface, it becomes a service provider
port. Ports that do not have double VLAN tunneling enabled are customer ports.
Default disabled
Format mode dvlan-tunnel
Mode Interface Config
Format no mode dvlan-tunnel
Mode Interface Config
Format show dot1q-tunnel [interface { | all}]