Kontron AT8404 CLI - Manual (Page 244)

Utility Commands AT8404
AT8404 CLI Reference Manual Page 4 - 30
For TFTP, SFTP and SCP, the parameter is the IP address or host name of the server,
is the path to the file, and is the name of the file you want to upload or download. For
SFTP and SCP, the parameter is the username for logging into the remote server via SSH.
Note: <ip6address> is also a valid parameter for routing packages that support IPv6.
Caution! Remember to upload the existing fastpath.cfg file off the switch prior to loading a new release
image in order to make a backup.
Table 1: Copy Parameters
Source Destination Description
nvram:backup-config nvram:startup-config Copies the backup configuration to the startup
configuration.
nvram:factory-settings nvram:current-
settings
Copies factory settings file to current settings file
nvram:factory-profile nvram:current-profile Copies factory profile file to current profile file
nvram:factory-config nvram:current-config Copies factory configuration file to current
configuration file
nvram:factory-all nvram:startup-all Copies all factory settings as configuration to be
used after reboot.
nvram:clibanner Copies the CLI banner to a server.
nvram:current-settings Contains configuration parameter
nvram:diag-report Copies diagnostics result file to a server
nvram:errorlog Copies the error log file to a server.
nvram:extra-profile Contains customer specific configuration files. This
“tar.gz”-file will be unpacked in the “/”-directory
nvram:fastpath.cfg Uploads the binary config file to a server.
nvram:log Copies the log file to a server.
nvram:oslog Copies the OS system log file to a server
nvram:script Copies a specified configuration script file to a
server.
nvram:settings Copies the file containing current settings to a
server
nvram:startup-config nvram:backup-config Copies the startup configuration to the backup
configuration.
nvram:startup-config Copies the startup configuration to a server.
nvram:traplog Copies the trap log file to a server.
system:running-config nvram:startup-config Saves the running configuration to nvram.
nvram:all-config Uploads all relevant config files.
nvram:clibanner Downloads the CLI banner to the system.
pld Downloads and updates PLD firmware. This needs
time. While running some progress information is
displayed. The PLD update is active only after a
power-cycle.
nvram:fastpath.cfg Downloads the binary config file to the system.