Kontron AT8404 CLI - Manual (Page 300)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 24
5.8.9 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent only if the Link
Trap flag setting associated with the port is enabled. See “snmp trap link-status” on page 5 - 26.
5.8.9.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
5.8.10 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent when a user
logs in to the terminal interface (EIA 232 or Telnet) and there is an existing terminal interface session.
5.8.10.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
5.8.11 snmp-server enable traps pll
This command enables the generation of traps in case a PLL status change has occurred.
5.8.11.1 no snmp-server enable traps pll
This command disables the generation of traps in case a PLL status change has occurred .
Note: This command may not be available on all platforms.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
Format no snmp-server enable traps linkmode
Mode Global Config
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config
Format no snmp-server enable traps multiusers
Mode Global Config
Default enabled
Format snmp-server enable traps pll
Mode Global Config
Format no snmp-server enable traps pll
Mode Global Config