Kontron AT8404 CLI - Manual (Page 95)

AT8404 Switching Commands
Page 2 - 59 AT8404 CLI Reference Manual
2.12.17.1 no storm-control unicast all level
This command sets the unicast storm recovery threshold to the default value and disables unicast storm recovery
for all interfaces.
2.12.18 storm-control unicast all rate
Use this command to configure the unicast storm recovery threshold for all interfaces in packets per second. If the
mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of unicast traffic is limited to
the configured threshold.
2.12.18.1 no storm-control unicast all rate
This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast
storm recovery.
2.12.19 storm-control flowcontrol
This command enables 802.3x flow control for the switch and only applies to full-duplex mode ports.
2.12.19.1 no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Format no storm-control unicast all level
Mode Global Config
Default 0
Format storm-control unicast all rate <0-33554431>
Mode Global Config
Format no storm-control unicast all rate
Mode Global Config
Note: 802.3x flow control works by pausing a port when the port becomes oversubscribed and dropping
all traffic for small bursts of time during the congestion condition. This can lead to high-priority and/or
network control traffic loss.
Default disabled
Format storm-control flowcontrol
Mode Global Config
Note: This command only applies to full-duplex mode ports.
Format no storm-control flowcontrol
Mode Global Config