Kontron AT8404 CLI - Manual (Page 136)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 100
2.19.1 set igmp querier
Use this command to enable IGMP Snooping Querier on the system, using Global Config mode, or on a VLAN.
Using this command, you can specify the IP Address that the Snooping Querier switch should use as the source
address while generating periodic queries.
If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled on it, IGMP Snooping
Querier functionality is disabled on that VLAN. IGMP Snooping functionality is re-enabled if IGMP Snooping is
operational on the VLAN.
The IGMP Snooping Querier application supports sending periodic general queries on the VLAN to solicit
membership reports.
2.19.1.1 no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional address parameter to reset
the querier address to 0.0.0.0.
2.19.2 set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in seconds that the switch
waits before sending another general query.
2.19.2.1 no set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time to its default value.
Note: The Querier IP Address assigned for a VLAN takes preference over global configuration.
Default disabled
Format set igmp querier [<vlan-id>] [address ipv4_address]
Mode • Global Config
• VLAN Mode
Format no set igmp querier [<vlan-id>] [address]
Mode • Global Config
• VLAN Mode
Default disabled
Format set igmp querier query-interval <1-18000>
Mode Global Config
Format no set igmp querier query-interval
Mode Global Config