Kontron AT8404 CLI - Manual (Page 125)

AT8404 Switching Commands
Page 2 - 89 AT8404 CLI Reference Manual
2.17.3.1 no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated VLAN ranges.
2.17.4 ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
2.17.4.1 no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
2.17.5 ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface. Configuring none for the limit
means the interface is not rate limited for Dynamic ARP Inspections.
2.17.5.1 no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default values of 15 pps and
1 second, respectively.
Default enabled
Format ip arp inspection vlan vlan-list logging
Mode Global Config
Format no ip arp inspection vlan vlan-list logging
Mode Global Config
Default enabled
Format ip arp inspection trust
Mode Interface Config
Format no ip arp inspection trust
Mode Interface Config
Note: The user interface will accept a rate limit for a trusted interface, but the limit will not be enforced
unless the interface is configured to be untrusted.
Default 15 pps for rate and 1 second for burst-interval
Format ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode Interface Config
Format no ip arp inspection limit
Mode Interface Config