Kontron AT8404 CLI - Manual (Page 211)

AT8404 Quality of Service (QoS) Commands
Page 3 - 37 AT8404 CLI Reference Manual
For the Broadcom 5650x platform, the mirror parameter allows the traffic matching this rule to be copied to the
specified , while the redirect parameter allows the traffic matching this rule to be forwarded to the
specified . The assign-queue and redirect parameters are only valid for a permit rule.
3.9.4 ipv6 traffic-filter
This command either attaches a specific IPv6 ACL identified by to an interface or associates with a VLAN
ID in a given direction. The parameter must be the name of an existing IPv6 ACL.
An optional sequence number may be specified to indicate the order of this mac access list relative to other IPv6
access lists already assigned to this interface and direction. A lower number indicates higher precedence order. If
a sequence number is already in use for this interface and direction, the specifiedIPv6 access list replaces the
currently attached IPv6 access list using that sequence number. If the sequence number is not specified for this
command, a sequence number that is one greater than the highest sequence number currently in use for this
interface and direction is used.
This command specified in Interface Config mode only affects a single interface, whereas the Global Config mode
setting is applied to all interfaces. The vlan keyword is only valid in the Global Config mode. The Interface Config
mode command is only available on platforms that support independent per-port class of service queue
configuration.
3.9.4.1 no ipv6 traffic-filter
This command removes an IPv6 ACL identified by from the interface(s) in a given direction.
3.9.5 show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL. Use the [name]
parameter to identify a specific IPv6 ACL to display.
Note: The mirror and redirect parameters are not available on the Broadcom 5630x platform.
Format {deny | permit} {every | {log] [assign-queue ] [{mirror |
redirect} ]
Mode IPv6-Access-List Config
Format ipv6 traffic-filter [vlan ] in[sequence <1-4294967295>]
Modes • Global Config
• Interface Config
Format no ipv6 traffic-filter [vlan ] in [sequence <1-
4294967295>]
Modes • Global Config
• Interface Config
Format show ipv6 access-lists [name]
Mode Privileged EXEC