Kontron AT8404 CLI - Manual (Page 177)

AT8404 Quality of Service (QoS) Commands
Page 3 - 3 AT8404 CLI Reference Manual
3.1.2 classofservice ip-dscp-mapping
This command maps an IP DSCP value to an internal traffic class. The value is specified as either an
integer from 0 to 63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22, af23, af31,
af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
The values can range from 0-6, although the actual number of available traffic classes depends
on the platform.
3.1.2.1 no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
3.1.3 classofservice trust
This command sets the class of service trust mode of an interface. You can set the mode to trust one of the Dot1p
(802.1p), IP DSCP, or IP Precedence packet markings. You can also set the interface mode to untrusted. If you
configure an interface to use Dot1p, the mode does not appear in the output of the show running config
command because Dot1p is the default.
3.1.3.1 no classofservice trust
This command sets the interface mode to the default value.
3.1.4 cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface queue. The total number
of queues supported per interface is platform specific. A value from 0-100 (percentage of link rate) must be specified
for each supported queue, with 0 indicating no guaranteed minimum bandwidth. The sum of all values entered must
not exceed 100.
Format classofservice ip-dscp-mapping
Mode Global Config
Format no classofservice ip-dscp-mapping
Mode Global Config
Note: The classofservice trust dot1p command will not be supported in future releases of the
software because Dot1p is the default value. Use the no classofservice trust command to set the
mode to the default value.
Default dot1p
Format classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted}
Modes • Global Config
• Interface Config
Format no classofservice trust
Modes • Global Config
• Interface Config