Kontron AT8404 CLI - Manual (Page 119)

AT8404 Switching Commands
Page 2 - 83 AT8404 CLI Reference Manual
2.16.9 ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping application.
2.16.9.1 no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping application.
2.16.10 ip dhcp snooping trust
Use this command to configure the port as trusted.
2.16.10.1 no ip dhcp snooping trust
Use this command to configure the port as untrusted.
2.16.11 ip verify source
Use this command to configure the IPSG source ID attribute to filter the data traffic in the hardware. Source ID is
the combination of IP address and MAC address. Normal command allows data traffic filtration based on the IP
address. With the “port-security” option, the data traffic will be filtered based on the IP and MAC addresses.
2.16.11.1 no ip verify source
Use this command to disable the IPSG configuration in the hardware. You cannot disable port-security alone if it is
configured.
Default disabled
Format ip dhcp snooping log-invalid
Mode Interface Config
Format no ip dhcp snooping log-invalid
Mode Interface Config
Default disabled
Format ip dhcp snooping trust
Mode Interface Config
Format no ip dhcp snooping trust
Mode Interface Config
Default the source ID is the IP address
Format ip verify source {port-security}
Mode Interface Config
Format no ip verify source
Mode Interface Config