Kontron AT8404 CLI - Manual (Page 100)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 64
2.13.9.1 no lacp actor admin state
Use this command the configure the default administrative values of actor state as transmitted by the Actor in
LACPDUs.
2.13.10 lacp actor admin state individual
Use this command to set LACP actor admin state to individual.
2.13.10.1 no lacp actor admin state individual
Use this command to set the LACP actor admin state to aggregation.
2.13.11 lacp actor admin state longtimeout
Use this command to set LACP actor admin state to longtimeout.
2.13.11.1 no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Format no lacp actor admin state {individual|longtimeout|passive}
Mode Interface Config
Format lacp actor admin state individual
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp actor admin state individual
Mode Interface Config
Format lacp actor admin state longtimeout
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp actor admin state longtimeout
Mode Interface Config
Note: This command is only applicable to physical interfaces.