beautypg.com

3 serviceport protocol, 4 network parms, 5 network protocol – Kontron AT8404 CLI User Manual

Page 279: 6 network mac-address, Serviceport protocol - 3, Network parms - 3, Network protocol - 3, Network mac-address - 3, At8404 management commands

background image

AT8404

Management Commands

Page 5 - 3

AT8404 CLI Reference Manual

5.1.3

serviceport protocol

This command specifies the network management port configuration protocol. If you modify this value, the change
is effective immediately. If you use the bootp parameter, the switch periodically sends requests to a BootP server
until a response is received. If you use the dhcp parameter, the switch periodically sends requests to a DHCP server
until a response is received. If you use the none parameter, you must configure the network information for the
switch manually.

5.1.4

network parms

This command sets the IP address, subnet mask and gateway of the device. The IP address and the gateway must
be on the same subnet.

5.1.5

network protocol

This command specifies the network configuration protocol to be used. If you modify this value, change is effective
immediately. If you use the bootp parameter, the switch periodically sends requests to a BootP server until a
response is received. If you use the dhcp parameter, the switch periodically sends requests to a DHCP server until
a response is received. If you use the none parameter, you must configure the network information for the switch
manually.

5.1.6

network mac-address

This command sets locally administered MAC addresses. The following rules apply:

Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered (b'0') or locally
administered (b'1').

Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual address (b'0') or a
group address (b'1').

The second character, of the twelve character macaddr, must be 2, 6, A or E.

A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').

Mode

Privileged EXEC

Format

serviceport protocol {none | bootp | dhcp}

Mode

Privileged EXEC

Format

network parms []

Mode

Privileged EXEC

Default

none

Format

network protocol {none | bootp | dhcp}

Mode

Privileged EXEC

Format

network mac-address

Mode

Privileged EXEC