Kontron AT8404 CLI - Manual (Page 251)

AT8404 Utility Commands
Page 4 - 37 AT8404 CLI Reference Manual
4.8.4.1 no default-router
This command removes the default router list.
4.8.5 dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are valid IP addresses; each
made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
4.8.5.1 no dns-server
This command removes the DNS Server list.
4.8.6 hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the MAC address of the
hardware platform of the client consisting of 6 bytes in dotted hexadecimal format. Type indicates the protocol of the
hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE 802.
4.8.6.1 no hardware-address
This command removes the hardware address of the DHCP client.
4.8.7 host
This command specifies the IP address and network mask for a manual binding to a DHCP client. Address and Mask
are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. The
prefix-length is an integer from 0 to 32.
Format no default-router
Mode DHCP Pool Config
Default none
Format dns-server [....]
Mode DHCP Pool Config
Format no dns-server
Mode DHCP Pool Config
Default ethernet
Format hardware-address
Mode DHCP Pool Config
Format no hardware-address
Mode DHCP Pool Config
Default none
Format host
Mode DHCP Pool Config