Kontron AT8404 CLI - Manual (Page 235)

AT8404 Utility Commands
Page 4 - 21 AT8404 CLI Reference Manual
4.5.3.1 no logging cli-command
This command disables the CLI command Logging feature.
4.5.4 logging console
This command enables logging to the console. You can specify the value as either an integer
from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error
(3), warning (4), notice (5), info (6), or debug (7).
4.5.4.1 no logging console
This command disables logging to the console.
4.5.5 logging host
This command enables logging to a host. You can configure up to eight hosts. The is the IP
address of the logging host. The indicates the type of address ipv4 or ipv6 or dns being passed.
The value is a port number from 1 to 65535. You can specify the value as either an
integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7).
4.5.6 logging host remove
This command disables logging to host. See 4.5.11 “show logging hosts“ on page 4 - 23 for a list of host indexes.
Format logging cli-command
Mode Global Config
Format no logging cli-command
Mode Global Config
Default disabled; critical when enabled
Format logging console [severitylevel]
Mode Global Config
Format no logging console
Mode Global Config
Default • port—514
• level—critical (2)
Format logging host [][]
Mode Global Config
Format logging host remove
Mode Global Config