Kontron AT8404 CLI - Manual (Page 114)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 78
2.15.2 macfilter adddest
Use this command to add the interface to the destination filter set for the MAC filter with the given and
VLAN of . The parameter must be specified as a 6-byte hexadecimal number in the format
of b1:b2:b3:b4:b5:b6. The parameter must identify a valid VLAN.
2.15.2.1 no macfilter adddest
This command removes a port from the destination filter set for the MAC filter with the given and VLAN
of . The parameter must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The parameter must identify a valid VLAN.
2.15.3 macfilter adddest all
This command adds all interfaces to the destination filter set for the MAC filter with the given and VLAN
of . The parameter must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The parameter must identify a valid VLAN.
2.15.3.1 no macfilter adddest all
This command removes all ports from the destination filter set for the MAC filter with the given and
VLAN of . The parameter must be specified as a 6-byte hexadecimal number in the format
of b1:b2:b3:b4:b5:b6. The parameter must identify a valid VLAN.
2.15.4 macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the MAC address of and
VLAN of . The parameter must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The parameter must identify a valid VLAN.
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format macfilter adddest <macaddr>
Mode Interface Config
Format no macfilter adddest <macaddr>
Mode Interface Config
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format macfilter adddest all <macaddr>
Mode Global Config
Format no macfilter adddest all <macaddr>
Mode Global Config
Format macfilter addsrc