Kontron AT8404 CLI - Manual (Page 243)

AT8404 Utility Commands
Page 4 - 29 AT8404 CLI Reference Manual
(Broadcom FASTPATH Routing) # ping 1.1.1.1 count 1 interval 3
Pinging 1.1.1.1 with 0 bytes of data:
----1.1.1.1 PING statistics----
1 packets transmitted,0 packets received, 100% packet loss
round-trip (msec) min/avg/max = 0/0/0
4.6.13 quit
This command closes the current telnet connection or resets the current serial connection. The system asks you
whether to save configuration changes before quitting.
4.6.14 reload
This command resets the switch without powering it off. Reset means that all network connections are terminated
and the boot code executes. The switch uses the stored configuration to initialize the switch. You are prompted to
confirm that the reset should proceed. The LEDs on the switch indicate a successful reset.
4.6.15 reload fast
The reload command is used to initiate a switch management restart via reset of the system. The reload fast
command will just do a clear config and will then re-apply the startup-config file.
4.6.16 copy
The copy command uploads and downloads files to and from the switch. You can also use the copy command to
manage the dual images (image1 and image2) on the file system. Upload and download files from a server by
using TFTP or Xmodem. SFTP and SCP are available as additional transfer methods if the software package
supports secure management.
Replace the and parameters with the options in Table 1 . For the source or
destination, use one of the following values:
{xmodem | tftp://|//
| sftp|scp://@|||}
Format quit
Modes • Privileged EXEC
• User EXEC
Format reload
Mode Privileged EXEC
Format reload fast
Mode Priviledged EXEC
Format copy
Mode Privileged EXEC