Kontron AT8404 CLI - Manual (Page 173)

AT8404 Switching Commands
Page 2 - 137 AT8404 CLI Reference Manual
(yes/no).
2.28.3 multicast (VLAN)
This command configures the VLAN based multicast handling. The command defines the handling for VLAN based
unregistered multicast addresses. The default handling in FASTPATH is that such packets are flooded (argument
‘default’). The user can change the behaviour that such packets are dropped (argument ‘none’). The flooding mode
is set per VLAN, the VLAN ID range is 1-4094. If a created VLAN is deleted again, the flooding mode is reset to
default.
2.28.4 show vlan multicast
This command displays the VLAN based multicast handling. The command displays for a specified VLAN ID (range
is 1-4094) or all created VLANs (inclusive default VLAN) the multicast flooding settings. The displayed fields are
• the VLAN Identifier (VID) associated with each VLAN
• the VLAN type (default, static or dynamic)
• the multicast flooding, indicating whether a packet with unregistered multicast address should be flooded or not
(yes/no).
2.28.5 set igmp proxy-report interfacemode
This command enables sending of IGMP reports to the specified interface. The reports are sent for all locally
subscribed multicast groups. This command is similar to set igmp mrouter interfacemode command, but multicast
traffic will not be forwarded to the interface by default. It don’t exist a separate “show” command, the setting may be
seen in “show running-config”.
2.28.5.1 no set igmp proxy-report interfacemode
This command disables sending of IGMP reports to the specified interface..
Format show port multicast
Mode Privileged Exec
Format multicast
Mode VLAN Config
Format show vlan multicast
Mode Privileged Exec
Format set igmp proxy-report interfacemode
Mode Interface Config
Format no set igmp proxy-report interfacemode
Mode Interface Config