Kontron AT8404 CLI - Manual (Page 190)

Quality of Service (QoS) Commands AT8404
AT8404 CLI Reference Manual Page 3 - 16
3.3.18 match srcip6
This command adds to the specified class definition a match condition based on the source IP address of a packet.
3.3.19 match srcl4port
This command adds to the specified class definition a match condition based on the source layer 4 port of a packet
using a single keyword or numeric notation. To specify the match condition as a single keyword notation, the value
for is one of the supported port name keywords (listed below). The currently supported
values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent
port number, which is used as both the start and end of a port range.
To specify the match condition as a numeric value, one layer 4 port number is required. The port number is an
integer from 0 to 65535.
3.3.20 match vlan
This command adds to the specified class definition a match condition based on the value of the layer 2 VLAN
Identifier field (the only tag in a single tagged packet or the first or outer tag of a double VLAN tagged packet). The
VLAN ID is an integer from 1 to 4095.
3.3.21 match secondary-vlan
This command adds to the specified class definition a match condition based on the value of the layer 2 secondary
VLAN Identifier field (the inner 802.1Q tag of a double VLAN tagged packet). The secondary VLAN ID is an integer
from 1 to 4095.
Default none
Format match srcip6
Mode Ipv6-Class-Map Config
Default none
Format match srcl4port { | <0-65535>}
Mode Ipv6-Class-Map Config
Class-Map Config
Note: This command is not available on the Broadcom 5630x platform.
Default none
Format match vlan <1-4095>
Mode Ipv6-Class-Map Config
Class-Map Config
Note: This command is not available on the Broadcom 5630x platform.
Default none