Kontron AT8404 CLI - Manual (Page 81)

AT8404 Switching Commands
Page 2 - 45 AT8404 CLI Reference Manual
authenticator PAE sets the controlled port mode to reflect the outcome of the authentication exchanges between the
supplicant, authenticator and the authentication server.
2.11.11.1 no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
2.11.12 dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only valid if the control
mode for the specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
2.11.13 dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
2.11.13.1 no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
2.11.14 dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled, the dot1x configuration
is retained and can be changed, but is not activated.
Default auto
Format dot1x port-control all {force-unauthorized | force-authorized | auto}
Mode Global Config
Format no dot1x port-control all
Mode Global Config
Format dot1x re-authenticate
Mode Privileged EXEC
Default disabled
Format dot1x re-authentication
Mode Interface Config
Format no dot1x re-authentication
Mode Interface Config
Default disabled
Format dot1x system-auth-control
Mode Global Config