Kontron AT8404 CLI - Manual (Page 145)

AT8404 Switching Commands
Page 2 - 109 AT8404 CLI Reference Manual
2.21.2.1 no set mld querier query_interval
Use this command to set the MLD Querier Query Interval time to its default value.
2.21.3 set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period. It is the time period that the switch remains in
Non-Querier mode once it has discovered that there is a Multicast Querier in the network.
2.21.3.1 no set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period to its default value.
2.21.4 set mld querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it discovers
the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier finds that the
other Querier’s source address is better (less) than the Snooping Querier’s address, it stops sending periodic
queries. If the Snooping Querier wins the election, then it will continue sending periodic queries.
2.21.4.1 no set mld querier election participate
Use this command to set the snooping querier not to participate in querier election but go into a non-querier mode
as soon as it discovers the presence of another querier in the same VLAN.
Default disabled
Format set mld querier query_interval <1-18000>
Mode Global Config
Format no set mld querier query_interval
Mode Global Config
Default 60 seconds
Format set mld querier timer expiry <60-300>
Mode Global Config
Format no set mld querier timer expiry
Mode Global Config
Default disabled
Format set mld querier election participate
Mode VLAN Config
Format no set mld querier election participate
Mode VLAN Config