Kontron AT8404 CLI - Manual (Page 308)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 32
5.8.36 show boardinfo snmp ipmi-trap
This command displays the settings for generation of IPMI traps. It displayes the general setting as well as all filter
rules..
5.9 RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote Authentication Dial-In User
Service (RADIUS) server on your network for authentication and accounting.
5.9.1 authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
5.9.1.1 no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
5.9.2 radius accounting mode
This command is used to enable the RADIUS accounting function.
5.9.2.1 no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS accounting
function is disabled.
5.9.3 radius server attribute
This command specifies the RADIUS client to use the NAS-IP Address attribute in the RADIUS requests. If the
specific IP address is configured while enabling this attribute, the RADIUS client uses that IP address while sending
NAS-IP-Address attribute in RADIUS communication.
Format show boardinfo snmp ipmi-trap
Mode Privileged Exec
Default disable
Format authorization network radius
Mode Global Config
Format no authorization network radius
Mode Global Config
Default disabled
Format radius accounting mode
Mode Global Config
Format no radius accounting mode
Mode Global Config