Kontron AT8404 CLI - Manual (Page 218)

Utility Commands AT8404
AT8404 CLI Reference Manual Page 4 - 4
Value-types are:
4.3.2 set board device-id
This command sets the device ID for the board. The device ID is used in the management device locator sensor
(show boardinfo sensors).
4.3.3 show atca ekeying
This command displays the current ekeying status together with admin mode and link status for all interfaces
4.3.4 ekeying (interface)
This command enables the ekeying for one port. Default is enabled.
4.3.4.1 no ekeying (interface)
This command disables the ekeying for one port. Default is enabled.
4.3.5 ekeying all (configure)
This command enables the ekeying for all ports for which ekeying is possible. Default is enabled.
Value-type Description
lower-non-critical Set lower non-critical threshold value
lower-critical
Set lower critical threshold value
lower-non-recover Set lower non-recoverable threshold value
upper-non-critical Set upper non-critical threshold value
upper-critical
Set upper critical threshold value
upper-non-recover Set upper non-recoverable threshold value
Format set board device-id
Mode Priviledged EXEC
Format set atca ekeying all
Mode Priviledged EXEC
Format ekeying
Mode Interface Config
Format no ekeying
Mode Interface Config
Format ekeying all
Mode Global Config