Kontron AT8404 CLI - Manual (Page 304)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 28
5.8.20 show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP Network
Manager. These messages alert the manager to events occurring within the switch or on the network. Six trap
receivers are simultaneously supported.
Example: The following shows an example of the CLI command.
(admin) #show snmptrap
Community Name IpAddress IPv6 Address Snmp Version Mode
Mytrap 0.0.0.0 2001::1 SNMPv2 Enable show trapflags
5.8.21 show trapflags
This command displays trap conditions. The command’s display shows all the enabled OSPFv2 and OSPFv3
trapflags. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap
condition is enabled and the condition is detected, the SNMP agent on the switch sends the trap to all enabled trap
receivers. You do not have to reset the switch to implement the changes. Cold and warm start traps are always
generated and cannot be disabled.
Client IP Address An IP address (or portion thereof) from which this device will accept SNMP packets with the
associated community. The requesting entity's IP address is ANDed with the Subnet Mask
before being compared to the IP address. Note: If the Subnet Mask is set to 0.0.0.0, an IP
address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0.
Client IP Mask A mask to be ANDed with the requesting entity's IP address before comparison with IP
address. If the result matches with IP address then the address is an authenticated IP
address. For example, if the IP address = 9.47.128.0 and the corresponding Subnet Mask =
255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming IP address
could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0.
Access Mode The access level for this community string.
Status The status of this community access entry.
Format show snmptrap
Mode Privileged EXEC
Term Definition
SNMP Trap Name The community string of the SNMP trap packet sent to the trap manager. The string is case
sensitive and can be up to 16 alphanumeric characters.
IP Address The IPv4 address to receive SNMP traps from this device.
IPv6 Address The IPv6 address to receive SNMP traps from this device.
SNMP Version SNMPv2
Mode The receiver's status (enabled or disabled).
Format show trapflags
Mode Privileged EXEC
Term Definition
Authentication
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether authentication
failure traps will be sent.
Term Definition