Kontron AT8404 CLI - Manual (Page 150)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 114
2.23.1.1 no lldp transmit
Use this command to return the local data transmission capability to the default.
2.23.2 lldp receive
Use this command to enable the LLDP receive capability.
2.23.2.1 no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
2.23.3 lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for LLDP. The
determines the number of seconds to wait between transmitting local data LLDPDUs. The
range is 1-32768 seconds. The is the multiplier on the transmit interval that sets the TTL in local
data LLDPDUs. The multiplier range is 2-10. The is the delay before re-initialization, and the
range is 1-0 seconds.
2.23.3.1 no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to
the default values.
2.23.4 lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic management set are
transmitted in the LLDPDUs. Use sys-name to transmit the system name TLV. To configure the system name, see
5.8.1 “snmp-server“on page 5 - 21. Use sys-descto transmit the system description TLV. Use sys-cap to transmit
Format no lldp transmit
Mode Interface Config
Default disabled
Format lldp receive
Mode Interface Config
Format no lldp receive
Mode Interface Config
Default • interval—30 seconds
• hold—4
• reinit—2 seconds
Format lldp timers [interval ] [hold ] [reinit
]
Mode Global Config
Format no lldp timers [interval] [hold] [reinit]
Mode Global Config