Kontron AT8404 CLI - Manual (Page 231)

AT8404 Utility Commands
Page 4 - 17 AT8404 CLI Reference Manual
the next set of <5-48> lines. The command terminal length 0 disables pagination and,
as a result, the output of the show running-config command is displayed immediately.
4.4.12.1 no terminal length
Use this command to set the terminal length to the default value.
4.4.13 show terminal length
Use this command to display the value of the user-configured terminal length size.
4.4.14 show boardinfo post-status
This command displays the system power on self test status.
4.4.15 show boardinfo sensors
This command displays the current sensor readings. It can either display a compressed list of all sensors or display
full readings for a specified sensor. The (of SDR) for a specific sensor is displayed in the compressed list
4.4.16 show boardinfo event-log
This command displays the event log of the board management controller. It can either display a summary (“info”)
or a list of all existing event-log records, a list with most recent records or a single record. The (of SEL)
is displayed in the list of records.
Default 24 lines per page
Format terminal length <0|5-48>
Mode Privileged EXEC
Format show terminal length
Mode Privileged EXEC
Format show boardinfo post-status system
Mode Priviledged EXEC
Format show boardinfo sensors { | brief}
Mode Priviledged EXEC
Note: It might take a while to get an output of the “show boardinfo sensors brief” command
Format show boardinfo event-log {info | list [last
| ]}
Mode Priviledged EXEC
Note: It might take a while to get an output of the “show boardinfo event-log list” command