Kontron AT8404 CLI - Manual (Page 286)

Management Commands AT8404
AT8404 CLI Reference Manual Page 5 - 10
5.3.8 telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session is active as long as the
session has not been idle for the value set. The time is a decimal value from 1 to 160.
5.3.8.1 no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.
5.3.9 show telnet
This command displays the current outbound Telnet settings. In other words, these settings apply to Telnet
connections initiated from the switch to a remote system.
5.3.10 show telnetcon
This command displays the current inbound Telnet settings. In other words, these settings apply to Telnet
connections initiated from a remote system to the switch.
Note: When you change the timeout value, the new value is applied to all active and inactive sessions
immediately. Any sessions that have been idle longer than the new timeout value are disconnected
immediately.
Default 5
Format telnetcon timeout <1-160>
Mode Privileged EXEC
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Also, any keystroke activates the new timeout duration.
Format no telnetcon timeout
Mode Privileged EXEC
Format show telnet
Modes • Privileged EXEC
• User EXEC
Term Definition
Outbound Telnet
Login Timeout
The number of minutes an outbound Telnet session is allowed to remain inactive before being
logged off.
Maximum Number
of Outbound
Telnet Sessions
The number of simultaneous outbound Telnet connections allowed.
Allow New
Outbound Telnet
Sessions
Indicates whether outbound Telnet sessions will be allowed.
Format show telnetcon
Modes • Privileged EXEC
• User EXEC