Kontron AT8404 CLI - Manual (Page 105)

AT8404 Switching Commands
Page 2 - 69 AT8404 CLI Reference Manual
2.13.23 lacp partner system-id
Use this command to configure the 6-octet MAC Address value representing the administrative value of the
Aggregation Port’s protocol Partner’s System ID. The valid range of <system-id> is 00:00:00:00:00:00 -
FF:FF:FF:FF:FF.
2.13.23.1 no lacp partner system-id
Use this command to configure the default value representing the administrative value of the Aggregation Port’s
protocol Partner’s System ID.
2.13.24 lacp partner system priority
Use this command to configure the administrative value of the priority associated with the Partner’s System ID. The
valid range for <priority> is 0 to 255.
2.13.24.1 no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the Partner’s System ID.
2.13.25 port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static mode for a new port-
channel is disabled, which means the port-channel is dynamic. However if the maximum number of allowable
dynamic port-channels are already present in the system, the static mode for a new port-channel enabled, which
means the port-channel is static.You can only use this command on port-channel interfaces.
Default 00:00:00:00:00:00
Format lacp partner system-id <system-id>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner system-id
Mode Interface Config
Default 0x0
Format lacp partner system priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner system priority
Mode Interface Config
Default disabled