Kontron AT8404 CLI - Manual (Page 101)

AT8404 Switching Commands
Page 2 - 65 AT8404 CLI Reference Manual
2.13.12 lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
2.13.12.1 no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
2.13.13 lacp actor port
Use this command to configure LACP actor port priority key.
2.13.14 lacp actor port priority
Use this command to configure the priority value assigned to the Aggregation Port. The valid range for <priority>
is 0 to 255.
2.13.14.1 no lacp actor port priority
Use this command to configure the default priority value assigned to the Aggregation Port.
2.13.15 lacp actor system priority
Use this command to configure the priority value associated with the LACP Actor’s SystemID. The range for
<priority> is 0 to 255.
Format lacp actor admin state passive
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp actor admin state passive
Mode Interface Config
Default 0x80
Format lacp actor port priority
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp actor port priority
Mode Interface Config
Default 0x80
Format lacp actor system priority <priority>
Mode Interface Config