3 show boardinfo pll status, 4 show boardinfo pll config, 5 set board clock bpl – Kontron AT8404 CLI User Manual
Page 325: 6 set board clock mux-amc, 7 set board clock mux-bpl, Show boardinfo pll status - 49, Show boardinfo pll config - 49, Set board clock bpl - 49, Set board clock mux-amc - 49, Set board clock mux-bpl - 49
AT8404
Management Commands
Page 5 - 49
AT8404 CLI Reference Manual
Format
5.16.3
show boardinfo pll status
This command shows the PLL status.
5.16.4
show boardinfo pll config
This command shows the PLL configuration. The PLL configuration parameters are described below for the “set”
command.
5.16.5
set board clock bpl
This command enables/disables a clock driver to the backplane.
5.16.6
set board clock mux-amc
This command selects/deselects a source for a AMC clock (MUX configuration). The source may be the PLL (8kHz/
19,44MHz auto selected by clock-ekeying), a backplane clock or another AMC clock. Default source is PLL. Settings
are stored permamantly.
5.16.7
set board clock mux-bpl
This command selects/deselects a source for a Backplane clock (MUX configuration). Default source is amcb1 tclkb.
Settings are stored permanently.
Format
set board pll tie {normal|adjust}
set board pll mode {normal|freerun}
set board pll oor {40_52_ppm|64_83_ppm}
set board pll reset {normal|reset}
set board pll source {none|clk1|clk2|clk3}
Mode
Priviledged EXEC
Format
show boardinfo pll status
Mode
Priviledged EXEC
Format
show boardinfo pll config
Mode
Priviledged EXEC
Format
set board clock bpl {clk1a|clk1b|clk2a|clk2b|clk3a|clk3b}
{enable|disable}
Mode
Priviledged EXEC
Format
set board clock mux-amc {amcb1|amcb2|amcb3|amcb4} {tclka|tclkc}
Mode
Priviledged EXEC
Format
set board clock mux-bpl