Kontron AT8404 CLI - Manual (Page 45)

AT8404 Switching Commands
Page 2 - 9 AT8404 CLI Reference Manual
2.2.5 spanning-tree bpduguard
Use this command to enable BPDU Guard on the switch.
2.2.5.1 no spanning-tree bpduguard
Use this command to disable BPDU Guard on the switch.
2.2.6 spanning-tree bpdumigrationcheck
Use this command to force a transmission of rapid spanning tree (RSTP) and multiple spanning tree (MSTP)
BPDUs. Use the parameter to transmit a BPDU from a specified interface, or use the all keyword
to transmit BPDUs from all interfaces. This command forces the BPDU transmission when you execute it, so the
command does not change the system configuration or have a “no” version.
2.2.7 spanning-tree configuration name
This command sets the Configuration Identifier Name for use in identifying the configuration that this switch is
currently using. The is a string of up to 32 characters.
2.2.7.1 no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
2.2.8 spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch
is currently using. The Configuration Identifier Revision Level is a number in the range of 0 to 65535.
Default disabled
Format spanning-tree bpduguard
Mode Global Config
Default disabled
Format no spanning-tree bpduguard
Mode Global Config
Format spanning-tree bpdumigrationcheck { | all}
Mode Global Config
Default base MAC address in hexadecimal notation
Format spanning-tree configuration name
Mode Global Config
Format no spanning-tree configuration name
Mode Global Config
Default 0
Format spanning-tree configuration revision <0-65535>