1 interface, 2 auto-negotiate, 1 no auto-negotiate – Kontron AT8404 CLI User Manual
Page 39: 3 auto-negotiate all, 1 no auto-negotiate all, 4 advertise speed, Interface - 3, Auto-negotiate - 3, Auto-negotiate all - 3, Advertise speed - 3

AT8404
Switching Commands
Page 2 - 3
AT8404 CLI Reference Manual
2.1.1
interface
This command gives you access to the Interface Config mode, which allows you to enable or modify the operation
of an interface (port).
2.1.2
auto-negotiate
This command enables automatic negotiation on a port.
2.1.2.1
no auto-negotiate
This command disables automatic negotiation on a port.
2.1.3
auto-negotiate all
This command enables automatic negotiation on all ports.
2.1.3.1
no auto-negotiate all
This command disables automatic negotiation on all ports.
2.1.4
advertise speed
This command sets auto-negotiation advertised speed parameters. If full/half-duplex is not specified the speed is
valid for both modes.
Format
interface
Mode
Global Config
Default
enabled
Format
auto-negotiate
Mode
Interface Config
Note: Automatic sensing is disabled when automatic negotiation is disabled.
Format
no auto-negotiate
Mode
Interface Config
Default
enabled
Format
auto-negotiate all
Mode
Global Config
Format
no auto-negotiate all
Mode
Global Config
Format
advertise speed <1000 | 100 | 10> [
Mode
Interface Config