Kontron AT8404 CLI - Manual (Page 158)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 122
2.24.4 lldp med all
Use this command to configure LLDP-MED on all the ports.
2.24.5 lldp med confignotification all
Use this command to configure all the ports to send the topology change notification.
2.24.6 lldp med faststartrepeatcount
Use this command to set the value of the fast start repeat count. [count] is the umber of LLDP PDUs that will be
transmitted when the product is enabled. The range is 1 to 10.
2.24.6.1 no lldp med faststartrepeatcount
Use this command to return to the factory default value.
2.24.7 lldp med transmit-tlv all
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set will be transmitted in
the Link Layer Discovery Protocol Data Units (LLDPDUs).
Format lldp med all
Mode Global Config
Format lldp med confignotification all
Mode Global Config
Default 3
Format lldp med faststartrepeatcount [count]
Mode Global Config
Format no lldp med faststartrepeatcount
Mode Global Config
Default By default, the capabilities and network policy TLVs are included.
Format lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode Global Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.