Kontron AT8404 CLI - Manual (Page 42)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 6
2.1.11 speed
This command sets the speed and duplex setting for the interface.
2.1.12 speed all
This command sets the speed and duplex setting for all interfaces.
2.1.13 show port
This command displays port information.
Format speed {<100 | 10> }
Mode Interface Config
Acceptable Values Definition
100h 100BASE-T half duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
Format speed all {<100 | 10> }
Mode Global Config
Acceptable Values Definition
100h 100BASE-T half duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
Format show port { | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
Type If not blank, this field indicates that this port is a special type of port. The possible values are:
• Mirror - this port is a monitoring port. For more information, see 2.14 “Port Mirroring” on
page 2 - 75.
• PC Mbr- this port is a member of a port-channel (LAG).
• Probe - this port is a probe port.
Admin Mode The Port control administration state. The port must be enabled in order for it to be allowed
into the network. - May be enabled or disabled. The factory default is enabled.
Physical Mode The desired port speed and duplex mode. If auto-negotiation support is selected, then the
duplex mode and speed is set from the auto-negotiation process. Note that the maximum
capability of the port (full duplex -100M) is advertised. Otherwise, this object determines the
port's duplex mode and transmission rate. The factory default is Auto.
Physical Status The port speed and duplex mode.
Link Status The Link is up or down.