Kontron AT8404 CLI - Manual (Page 186)

Quality of Service (QoS) Commands AT8404
AT8404 CLI Reference Manual Page 3 - 12
3.3.5.1 no match class-map
This command removes from the specified class definition the set of match conditions defined for another class. The
is the name of an existing DiffServ class whose match conditions are being referenced by the
specified class definition.
3.3.6 match cos
This command adds to the specified class definition a match condition for the Class of Service value (the only tag
in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The value may be from
0 to 7.
3.3.7 match secondary-cos
This command adds to the specified class definition a match condition for the secondary Class of Service value (the
inner 802.1Q tag of a double VLAN tagged packet). The value may be from 0 to 7..
3.3.8 match destination-address mac
This command adds to the specified class definition a match condition based on the destination MAC address of a
packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers
separated by colons (e.g., 00:11:22:dd:ee:ff). The > parameter is a layer 2 MAC address bit mask, which
Format no match class-map
Mode Class-Map Config
Ipv6-Class-Map Config
Note: This command is not available on the Broadcom 5630x platform.
Default none
Format match cos <0-7>
Mode Class-Map Config
Ipv6-Class-Map Config
Note: This command is supported on the following platforms:
• BCM56314
• BCM56504
• BCM56214
• BCM56224
Default none
Format match secondary-cos <0-7>
Mode Class-Map Config