Kontron AT8404 CLI - Manual (Page 104)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 68
2.13.20.1 no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
2.13.21 lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is 0 to 65535.
2.13.21.1 no lacp partner port id
Use this command to set the LACP partner port id to the default.
2.13.22 lacp partner port priority
Use this command to configure the LACP partner port priority. The valid range for <priority> is 0 to 255.
2.13.22.1 no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Format no lacp partner admin state passive
Mode Interface Config
Default 0x80
Format lacp partner port-id <port-id>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format lacp partner port-id
Mode Interface Config
Default 0x0
Format lacp partner port priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner port priority
Mode Interface Config