Kontron AT8404 CLI - Manual (Page 335)

FASTPATH log messages AT8404
AT8404 CLI Reference Manual Page B - 2
B. FASTPATH Log Messages
This chapter lists common log messages that are provided by FASTPATH, along with information regarding the
cause of each message. There is no specific action that can be taken per message. When there is a problem being
diagnosed, a set of these messages in the event log, along with an understanding of the system configuration and
details of the problem) will assist Broadcom in determining the root cause of such a problem.
The Log Messages chapter includes the following sections:
• “Core” on page B - 2
• “Utilities” on page B - 3
• “Management” on page B - 5
• “Switching” on page B - 7
• “QoS” on page B - 12
• “Technologies” on page B - 13
• “O/S Support” on page B - 14
B.1 Core
Note: This chapter is not a complete list of all syslog messages.
Table 1: BSP Log Messages
Component Message Cause
BSP Event(0xaaaaaaaa) Switch has restarted.
BSP Starting code... BSP initialization complete, starting FastPath
application.
Table 2: NIM Log Messages
Component Message Cause
NIM NIM: L7_ATTACH out of order for intIfNum(x)
unit x slot x port x
Interface creation out of order
NIM NIM: Failed to find interface at unit x slot x port
x for event(x)
There is no mapping between the USP and
Interface number
NIM NIM: L7_DETACH out of order for intIfNum(x)
unit x slot x port x
Interface creation out of order
NIM NIM: L7_DELETE out of order for intIfNum(x)
unit x slot x port x
Interface creation out of order
NIM NIM: event(x),intf(x),component(x), in wrong
phase
An event was issued to NIM during the wrong
configuration phase (probably Phase 1, 2, or
WMU)
NIM NIM: Failed to notify users of interface change Event was not propagated to the system
NIM NIM: failed to send message to NIM message
Queue.
NIM message queue full or non-existent
NIM NIM: Failed to notify the components of
L7_CREATE event
Interface not created