beautypg.com

9 show serviceport, 2 console port access commands, Show serviceport - 5 – Kontron AT8404 CLI User Manual

Page 281: 2 console port access commands - 5, At8404 management commands

background image

AT8404

Management Commands

Page 5 - 5

AT8404 CLI Reference Manual

Example: The following shows example CLI display output for the network port.

(Ethernet Fabric) #show network

Interface Status............................... Always Up
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
Burned In MAC Address.......................... 00:10:18:82:03:37
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1

5.1.9

show serviceport

This command displays service port configuration information.

Example: The following shows example CLI display output for the service port.

(Ethernet Fabric) #show serviceport

Interface Status............................... Up
IP Address..................................... 10.230.3.51
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.230.3.1
ServPort Configured Protocol Current........... DHCP
Burned In MAC Address.......................... 00:A0:A5:5D:20:3C

5.2

Console Port Access Commands

This section describes the commands you use to configure the console port. You can use a serial cable to connect
a management host directly to the console port of the switch.

Network

Configuration

Protocol Current

The network protocol being used. The options are bootp | dhcp | none.

Format

show serviceport

Mode

Privileged EXEC

Term

Definition

IP Address

The IP address of the interface. The factory default value is 0.0.0.0.

Subnet Mask

The IP subnet mask for this interface. The factory default value is 0.0.0.0.

Default Gateway

The default gateway for this IP interface. The factory default value is 0.0.0.0.

ServPort

Configuration

Protocol Current

The network protocol used on the last, or current, power-up cycle, if any.

Burned in MAC

Address

The burned in MAC address used for in-band connectivity.

Term

Definition