Kontron AT8404 CLI - Manual (Page 152)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 116
2.23.7 lldp notification-interval
Use this command to configure how frequently the system sends remote data change notifications. The
parameter is the number of seconds to wait between sending notifications. The valid interval range is
5-3600 seconds.
2.23.7.1 no lldp notification-interval
Use this command to return the notification interval to the default value.
2.23.8 clear lldp statistics
Use this command to reset all LLDP statistics, including MED-related information.
2.23.9 clear lldp remote-data
Use this command to delete all information from the LLDP remote data table, including MED-related information.
2.23.10 show lldp
Use this command to display a summary of the current LLDP configuration.
Default 5
Format lldp notification-interval
Mode Global Config
Format no lldp notification-interval
Mode Global Config
Format clear lldp statistics
Mode Privileged Exec
Format clear lldp remote-data
Mode Global Config
Format show lldp
Mode Privileged Exec
Term Definition
Transmit Interval How frequently the system transmits local data LLDPDUs, in seconds.
Transmit Hold
Multiplier
The multiplier on the transmit interval that sets the TTL in local data LLDPDUs.
Re-initialization
Delay
The delay before re-initialization, in seconds.
Notification
Interval
How frequently the system sends remote data change notifications, in seconds.