Kontron AT8404 CLI - Manual (Page 89)

AT8404 Switching Commands
Page 2 - 53 AT8404 CLI Reference Manual
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped.
Therefore, the rate of broadcast traffic is limited to the configured threshold.
2.12.2.1 no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an interface and disables
broadcast storm recovery.
2.12.3 storm-control broadcast rate
Use this command to configure the broadcast storm recovery threshold for an interface in packets per second. If the
mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited
to the configured threshold.
2.12.3.1 no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an interface and disables
broadcast storm recovery.
2.12.4 storm-control broadcast all
This command enables broadcast storm recovery mode for all interfaces. If the mode is enabled, broadcast storm
recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic will be limited to the configured
threshold.
2.12.4.1 no storm-control broadcast all
This command disables broadcast storm recovery mode for all interfaces.
Default 5
Format storm-control broadcast level <0-100>
Mode Interface Config
Format no storm-control broadcast level
Mode Interface Config
Default 0
Format storm-control broadcast rate <0-33554431>
Mode Interface Config
Format no storm-control broadcast rate
Mode Interface Config
Default disabled
Format storm-control broadcast all
Mode Global Config