Kontron AT8404 CLI - Manual (Page 129)

AT8404 Switching Commands
Page 2 - 93 AT8404 CLI Reference Manual
Example: The following shows example CLI display output for the command.
(Switching) #show ip arp inspection interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
0/1 Untrusted 15 1
0/2 Untrusted 10 10
2.17.13 show arp access-list
Use this command to display the configured ARP ACLs with the rules. Giving an ARP ACL name as the argument
will display on ly the rules in that ARP ACL.
Example: The following shows example CLI display output for the command.
(Switching) #show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08
2.18 IGMP Snooping Configuration Commands
This section describes the commands you use to configure IGMP snooping. FASTPATH software supports IGMP
Versions 1, 2, and 3. The IGMP snooping feature can help conserve bandwidth because it allows the switch to
forward IP multicast traffic only to connected hosts that request multicast traffic. IGMPv3 adds source filtering
capabilities to IGMP versions 1 and 2.
2.18.1 set igmp
This command enables IGMP Snooping on the system (Global Config Mode) or an interface (Interface Config
Mode). This command also enables IGMP snooping on a particular VLAN (VLAN Config Mode) and can enable
IGMP snooping on all interfaces participating in a VLAN.
If an interface has IGMP Snooping enabled and you enable this interface for routing or enlist it as a member of a
port-channel (LAG), IGMP Snooping functionality is disabled on that interface. IGMP Snooping functionality is re-
Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
Format show arp access-list [acl-name]
Mode • Privileged EXEC
• User EXEC