8 set board clock override, 9 set board clock receiver, 10 set board clock source – Kontron AT8404 CLI User Manual
Page 326: 11 show boardinfo clock bpl, Set board clock override - 50, Set board clock receiver - 50, Management commands at8404
Management Commands
AT8404
AT8404 CLI Reference Manual
Page 5 - 50
5.16.8
set board clock override
The command overrides the clock ekeying for an AMC clock. A correct MUX setting (set board clock mux-amc) must
be done before. If the source for an AMC clock is set to PLL, the clock frequence must be specified too, otherwise
the related parameter is not used.
5.16.9
set board clock receiver
The command configures the clock description for clocks from the AMC. You can specify for family and accuracy
either default values (sonet/stratum3 or sonet/stratum3E) or any protocol value (0..255). You can specify for
frequency a well-known value or any other value (unit is Hz).
5.16.10
set board clock source
The command configures the clock description for clocks to the AMC. You can specify for family and accuracy either
default values (sonet/stratum3 or sonet/stratum3E) or any protocol value (0..255). You can specify for frequency a
well-known value or any other value (unit is Hz).
5.16.11
show boardinfo clock bpl
This command shows the configuration of backplane clocks. The backplane clocks are displayed with the state
(enabled/disabled) and (if enabled) the mapped AMC source with clock configuration attributes.
Mode
Priviledged EXEC
Format
set board clock override
[2kHz|8kHz|19_44MHz]
Mode
Priviledged EXEC
Format
set board clock receiver
{
tclkb|tclkd}
enable sonet
{stratum3|stratum3E}
{8kHz|1_544MHz|2_048_MHz|19_44MHz}
set board clock receiver
enable
disabl
e
Mode
Priviledged EXEC
Format
set board clock source
{stratum3|stratum3E} {8kHz|1_544MHz|2_048_MHz|19_44MHz}
set board clock source
{8kHz|1_544MHz|2_048_MHz|19_44MHz}
set board clock source
Mode
Priviledged EXEC
Format
show boardinfo clock bpl
Mode
Priviledged EXEC