Kontron AT8404 CLI - Manual (Page 269)

AT8404 Utility Commands
Page 4 - 55 AT8404 CLI Reference Manual
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
4.11.12.1 no debug lacp packet
This command disables tracing of LACP packets.
4.11.13 debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. receive traces only received MLD
snooping packets and transmit traces only transmitted MLD snooping packets. When neither keyword is used in
the command, then all MLD snooping packet traces are dumped. Vital information such as source address,
destination address, control packet type, packet length, and the interface on which the packet is received or
transmitted is displayed on the console.
4.11.13.1 no debug mldsnooping packet
Use this command to disable debug tracing of MLD snooping packet reception and transmission.
4.11.14 debug ping packet
This command enables tracing of ICMP echo requests and responses. The command traces pings on the network
port/ serviceport for switching packages. For routing packages, pings are traced on the routing ports as well.
A sample output of the trace message is shown below.
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128) 20 % Pkt TX -
Intf: 1/0/1(1),
SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21 % Pkt RX -
Intf: 1/0/1(1), S
RC_IP:10.50.50.1, DEST_IP:10.50.50.2, Type:ECHO_REPLY
Format debug lacp packet
Mode Privileged EXEC
Format no debug lacp packet
Mode Privileged EXEC
Default disabled
Format debug mldsnooping packet [receive|transmit]
Mode Privileged EXEC
Default disabled
Format debug ping packet
Mode Privileged EXEC