Kontron AT8404 CLI - Manual (Page 82)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 46
2.11.14.1 no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
2.11.15 dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on this port.
Depending on the token used and the value (in seconds) passed, various timeout configurable parameters are set.
The following tokens are supported:
2.11.15.1 no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on this port to the
default values. Depending on the token used, the corresponding default values are set.
Format no dot1x system-auth-control
Mode Global Config
Tokens Definition
reauth-period The value, in seconds, of the timer used by the authenticator state machine on this port to
determine when re-authentication of the supplicant takes place. The reauth-period must be a
value in the range 1 - 65535.
quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port to
define periods of time in which it will not attempt to acquire a supplicant. The quiet-period must
be a value in the range 0 - 65535.
tx-period The value, in seconds, of the timer used by the authenticator state machine on this port to
determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-
period must be a value in the range 1 - 65535.
supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to
timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.
server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to
timeout the authentication server. The supp-timeout must be a value in the range 1 - 65535.
Default • guest-vlan-period: 90 seconds
• reauth-period: 3600 seconds
• quiet-period: 60 seconds
• tx-period: 30 seconds
• supp-timeout: 30 seconds
• server-timeout: 30 seconds
Format dot1x timeout {{guest-vlan-period } | {reauth-period }
| {quiet-period } | {tx-period } | {supp-timeout
} | {server-timeout }}
Mode Interface Config
Format no dot1x timeout {guest-vlan-period | reauth-period | quiet-period | tx-
period | supp-timeout | server-timeout}
Mode Interface Config