Kontron AT8404 CLI - Manual (Page 176)

Quality of Service (QoS) Commands AT8404
AT8404 CLI Reference Manual Page 3 - 2
3. Quality of Service (QoS) Commands
This chapter describes the Quality of Service (QoS) commands available in the FASTPATH CLI.
The QoS Commands chapter contains the following sections:
• 3.1 “Class of Service (CoS) Commands” on page 3 - 2
• 3.2 “Differentiated Services (DiffServ) Commands” on page 3 - 8
• 3.3 “DiffServ Class Commands” on page 3 - 9
• 3.4 “DiffServ Policy Commands” on page 3 - 17
• 3.5 “DiffServ Service Commands” on page 3 - 21
• 3.6 “DiffServ Show Commands” on page 3 - 22
• 3.7 “MAC Access Control List (ACL) Commands” on page 3 - 26
• 3.8 “IP Access Control List (ACL) Commands” on page 3 - 30
• 3.9 “IPv6 Access Control List (ACL) Commands” on page 3 - 35
• 3.10 “Auto-Voice over IP Commands” on page 3 - 38
3.1 Class of Service (CoS) Commands
This section describes the commands you use to configure and view Class of Service (CoS) settings for the switch.
The commands in this section allow you to control the priority and transmission rate of traffic.
3.1.1 classofservice dot1p-mapping
This command maps an 802.1p priority to an internal traffic class. The values can range from 0-
7. The values range from 0-6, although the actual number of available traffic classes depends
on the platform. For more information about 802.1p priority, see 2.5 “Voice VLAN Commands” on page 2 - 32
.
3.1.1.1 no classofservice dot1p-mapping
This command maps each 802.1p priority to its default internal traffic class value.
Note: The commands in this chapter are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configuration
command, there is a show command that displays the configuration setting.
Note: Commands you issue in the Interface Config mode only affect a single interface. Commands you
issue in the Global Config mode affect all interfaces.
Format classofservice dot1p-mapping
Modes • Global Config
• Interface Config
Format no classofservice dot1p-mapping
Modes • Global Config
• Interface Config