Kontron AT8404 CLI - Manual (Page 93)

AT8404 Switching Commands
Page 2 - 57 AT8404 CLI Reference Manual
2.12.12.1 no storm-control multicast all rate
This command sets the multicast storm recovery threshold to the default value for all interfaces and disables
multicast storm recovery.
2.12.13 storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled, unicast storm recovery
is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be
limited to the configured threshold.
2.12.13.1 no storm-control unicast
This command disables unicast storm recovery mode for an interface.
2.12.14 storm-control unicast level
This command configures the unicast storm recovery threshold for an interface as a percentage of link speed, and
enables unicast storm recovery. If the mode is enabled, unicast storm recovery is active, and if the rate of unknown
L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.This command also enables unicast storm recovery mode for an interface.
2.12.14.1 no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface and disables unicast
storm recovery.
Format no storm-control multicast all rate
Mode Global Config
Default disabled
Format storm-control unicast
Mode Interface Config
Format no storm-control unicast
Mode Interface Config
Default 5
Format storm-control unicast level <0-100>
Mode Interface Config
Format no storm-control unicast level
Mode Interface Config