Kontron AT8404 CLI - Manual (Page 305)

AT8404 Management Commands
Page 5 - 29 AT8404 CLI Reference Manual
5.8.22 snmptrap notification
This command specifies the notification type (trap or inform request) for generating traps. The default is ‘trap’. The
‘inform request’ is only possible for version 2c. The version is not checked, but setting ‘inform request’ for version 1
means that the trap is sent as ‘trap’ anyway.
5.8.23 snmp-server engine-id
This command configures the algorithm used to generate the Snmp-Engine-ID. This object is used only in SNMPv3.
The algorithm should generate a unique ID (see RFC 3411). It can be selected a RFC 3411 defined algorithm
containing the MAC address (mac), a specified IP address (ip) or a specified text (text). It may be also selected a
simple enterprise specific algorithm (simple) containing the SNMP port (161). Note that this algorithm is not unique.
Default is the RFC 3411 related algorithm with MAC address (mac).
A new configured algorithm will become effective not before the system has been rebooted because the Snmp-
Engine-ID is used also to encrypt the community and user passwords. Therefore the user have to save the
configuration and reboot the system to activate the new algorithm..
5.8.24 show snmp-engine-id
This command displays the algorithm used to generate the Snmp-Engine-ID. It displays the configured and the
currently active algotithm. A configured algorithm will become active after the next system reboot.
5.8.25 set board snmp site
This command configures the sites used to monitor IPMI information via SNMP. The parameter ‘local’ specifies the
local site, remote sites must be specified by the related IPMB address. The IPMB address can be specified decimal
or hexadecimal (prefix ‘0x’)..
Link Up/Down Flag Can be enabled or disabled. The factory default is enabled. Indicates whether link status traps
will be sent.
Multiple Users Flag Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will be
sent when the same user ID is logged into the switch more than once at the same time (either
through Telnet or the serial port).
Spanning Tree
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether spanning tree
traps are sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps are
sent.
PLL clock trap Can be enabled or disabled. The factory default is disabled. Indicates a PLL state change.
Format snmptrap notification {trap | inform}
Mode Global Config
Format snmp-server engine-id {mac | ip | text | simple}
Mode Global Config
Format show snmp-engine-id
Mode Privileged Exec
Format set board snmp site {local | }
Term Definition